Views: 53 Author: Site Editor Publish Time: 2022-07-20 Origin: Site
A good hand impulse sealer can provide more protection to the product, extend the life cycle, and provide an extra layer of protection during shipping.
What are the installation steps for hand impulse sealer?
What is the reason why the hand impulse sealer can't seal the mouth?
What is the principle structure of the hand impulse sealer?
Put the sealing film on the film supply roller and press it tightly.
Pull the roll film of the hand impulse sealer through the lead screw, the bottom surface of the upper die, and the guide roll is wound on the take-up roll.
Turn on the hand impulse sealer to warm up.
Set the heat sealing temperature of your own film. If you don't know it, choose to adjust it to 120 degrees, and then increase it if the sealing is not tight. Of course, it can't be sealed until the heating lamp stops.
Why can't the hand impulse sealer seal the mouth? What should I do if the hand impulse sealer can't seal the mouth? Three reasons are summarized for you to check one by one:
1. Check the sealing temperature, otherwise the minimum heat sealing requirements have been reached.
2. Whether the material of the fast food box is the same as that of the sealing film.
3. Check whether the heating plate (mold) of the sealing machine is heated normally.
1. The hand impulse sealer consists of a frame, a deceleration and speed regulation transmission mechanism, a heating and cooling mechanism, a sealing and printing mechanism, a conveying device and an electrical and electronic control system.
2. The hand impulse sealer is connected to the power supply, and each agency starts to work. The electric heating element is heated after being energized, so that the upper and lower heating blocks are heated up sharply and adjusted to the required temperature through the control system; the embossing wheel rotates; the cooling system starts to cool according to the needs; the conveyor belt is rotated and adjusted to the required speed by the speed regulating device.
3. When the package containing the articles is placed on the conveyor belt, the sealing part of the bag is automatically sent to the two sealing belts in operation and brought into the heating area, and the heat of the heating block is transmitted to the sealing part of the bag through the sealing belt. , the film is heated and melted and softened, and then passed through the cooling zone to make the surface temperature of the film drop appropriately, and then rolled by a knurling wheel (or printing wheel) to bond the upper and lower plastic films of the sealing part and press out a mesh pattern (or printing). The sealed bag is sent out of the machine by the guiding rubber belt and the conveyor belt to complete the sealing operation.
Zhejiang Hongzhan Packing Machinery Co., Ltd was established in 2000, our main products are sealing machines and packing machines such as pouch packing machines, hand packing machines, hand sealing machines, etc.