The shrinking packing machine  uses far-infrared radiation to directly heat various specifications of films. The product is transported to the shrinking furnace through the conveyor belt, and the product is loaded with shrink wrapping film. In no way affect the packaging.

What is the process of using the shrinking packing machine?

What should I pay attention to when operating the shrinking packing machine?

What can I do when the shrinking packing machine can't feed normally?

What is the process of using the shrinking packing machine?

⒈ Close the left power switch;

⒉ Close the side heat switch, and adjust the side heat knob to about 4-5;

⒊Close the upper and lower heat switches, and adjust the lower heat knob to about 4-5;

⒋Close the conveying switch, and adjust the conveying knob to about 4-5;

⒌Adjust the heating temperature (can be set at about 130℃ first);

⒍ After the above operations are completed, let the machine run for about 3 minutes and then turn on the hot air switch (the hot air switch may not be turned on in actual operation);

⒎Put on the items that have been installed with shrink film, and shrink packaging can be performed;

⒏ In the actual situation, if there are too many wrinkles after shrinkage, the conveying speed can be reduced or the heating temperature can be increased; on the contrary, if there is excessive shrinkage, the temperature can be reduced;

⒐ After the packaging, turn off the three-stage heating switch first, but the conveying motor and the hot air motor continue to run for about 10 minutes, and then cut off the entire power supply.

What should I pay attention to when operating the shrinking packing machine?

⒈shrinking packing machine is (220v/380v voltage) single-phase/three-phase four-wire system, in which the zero line must be connected to the machine, otherwise the machine cannot run normally;

⒉shrinking packing machine has stainless steel heating pipes, which are installed on both sides, very red and bright when heating;

3. Note that the temperature of the shrinking chamber should be controlled below 230°C (sixth gear). If the temperature is exceeded, the circuit will be prematurely aged and the life of electrical components will be reduced;

⒋When the shrinking packing machine is used for more than three months, the aging of the wires in the shrinking room should be checked and replaced as appropriate.

What can I do when the shrinking packing machine can't feed normally?

The film material of the heat shrink packaging machine is easy to shift during the packaging production and cannot be fed normally, which will make the heat shrink packaging machine unable to heat shrink the object normally, then you can adjust the film roll position and tension balance bar, if both are invalid , which can be solved by adjusting the angle of the upper triangle. If the upper film material deviates from the clamping chain, the upper triangle plate can be adjusted clockwise; the lower film material deviates from the clamping chain, and the upper triangle plate can be adjusted counterclockwise. This resolves the failure problem.

ZHEJIANG HONGZHAN PACKING MACHINERY CO., LTD which has been around for more than several years, focuses on manufacturing shrinking packing machines. Here you will find the shrinking packing machine you need.